No decals or mounting hardware is included. For individual product pictures, please visit the "Plastic" category.Some larger orders may take a few weeks if product is out of stock. Plastic orders that are not in stock on the shelf may take up to a week to be made. We do not stock 100's of each item and are not Amazon. They are designed to fit the models listed in the title or the drop down list if the product has that option. We do not sell OEM parts. What type of finish do your products have? All of our plastic has a satin finish.
We do not offer a high gloss product. Why don't stickers stick on my plastic?All of our plastic products have an Armor All protective coating applied before they leave the shop. Use a brake cleaner or engine degreaser before applying any decals. All of our parts are vacuum formed replicas. We make them as close to the factory OEM parts as possible. However, please do not expect the same sharp lines and perfect fitting pieces like the injection molded original parts.
We are constantly updating molds and making parts fit better. If you have an issue with something fitting, please give us a call. We will do our best to help you get it to fit properly. Before installing your parts, please verify that you have ordered the correct parts for your make and model bike.
Most parts that we sell are model specific. Some plastic products that are produced by DC Plastics do not come pre-drilled due to the variation in mounting hole locations on each individual vintage motocross bike. In order to get the proper fit on your motorcycle, please measure the mounting holes before drilling each hole.
Do not drill each hole in the center of the mounting eyelet before checking to see if they are properly lined up on your bike. In most cases, the holes will not be drilled in the middle of each mounting eyelet. All items have a coat of Armor All applied before they are packaged. If you are going to install decals, the plastic will need to be cleaned with a degreaser such as mineral spirits, parts cleaner, etc.
Some panels and fenders require the use of spacers behind the mounting eyelet. Due to the molding process, we are unable to make some of the mounts as deep as the original parts. To achieve the same mounting position, you will need to use spacers behind the part.We are unable to form most mounting tabs on the underside of the part. Some models may require you to bolt them to the frame if they originally had the pop in nipples on the underside of the part.
You may have to zip tie side panels to the frame in one spot for extra stability. Most models do not require this though. Vacuum formed headlight holders and enduro style rear fenders will take a bit of work to get them to fit properly.
Due to the vacuum forming process, many of the tabs, nuts and mounts cannot be molded into or on the underside of the part. If the parts are shuffled into an awkward position, please note that you will have to bend them back into the correct shape. The parts can be bent and tweaked as needed. You will not break them by doing this.
Use light heat from a hair dryer or heat gun to assist. The item "1985-1988 Yamaha BW 200 BW200 Big Wheel Plastic Kit" is in sale since Wednesday, July 19, 2017. This item is in the category "eBay Motors\Parts & Accessories\Motorcycle Parts\Antique, Vintage, Historic". The seller is "dcplastics" and is located in Sebewaing, Michigan. This item can be shipped worldwide.