NINE levels of indication from six red, yellow and green LEDs. INDICATES BATTERY OVERCHARGE - protect your bike, car or system from overvoltage. Voltage : SELECTABLE 6V, 12v, 24V (Max 30v). Accuracy to +/- 0.15v.SIX selectable voltage'maps' to chose from for each of the 6,12,24v ranges. Settings retained after power off for 100 years. THREE different display modes (bargraph, Single LED and flashing LED). Low Power Consumption : 0.4mA in flashing mode, 3mA in single LED mode, 10mA maximum in multi led mode (all LEDs lit). Just two wires to connect WITH 120MM (4 FOOT) LEADS.
Supplied with comprehensive printed instruction sheet. Its annoying when your battery goes flat without warning. Or your regulator fails, and fries your electrics! This neat little unit can be used wherever you have a 6v, 12v, or 24v based electrical system. Perhaps your bike, car, camper or boat, golf buggy, or that battery you have to power the DC lighting in your shed can go flat on you without warning, or you would like some idea of how much juice you have left?
This compact gadget will show you by means of six bright LEDs the voltage level of your battery. Simple fitment instructions are included with the device. A fitting kit comprising tie wrap and rear mounted adhesive pads and base is supplied to allow fitment to any flat or curved surface - fix to dashboard, wall, handlebars, any surface you can stick to or loop cable ties around. A 1200mm cable (4 ft) with optional fuse is included, plus 3 "scotchlock" connectors to splice into a suitable point in your cabling.
In single LED mode, the LED will travel to the current battery status level. In multi-LED mode, all LEDs will light to the current battery status level. In flashing LED mode, a single LED will'blink' approx once per second to indicate current level, drawing an absolute mimimal power from your battery. The red LED has multi-functional capability. Once the red LED illuminates, the battery is considered discharged.If further current is drawn, it may deep-discharge and reduce future battery life. User warning against further discharge is indicated by slow flashing, and critical level indicated by rapid flashing of the red LED. If the system has an'overcharge' state, for example, a motorcycle alternator regulator has failed, allowing a high voltage to be supplied to the battery and electrical system, the red and green LEDs will flash together to warn of possible impending damage to your electrical system. The unit is simply programmed to the voltage and mode you need via the supplied comprehensive instructions. Unit can be set according to below tables. References to Lead acid batteries below include Gel and AGM types. 4 = Vehicle With Charging.
Note 1: For 24v, double the above values. For 6v, use half the above values. Note 2: Refer to your batterys data sheet especially if you wish to use other than range 1 to 4.Note 3 : 0.4mA flashing, 3mA single LED, 10mA in bargraph mode. The item "6v 12v 24v LED battery status alternator monitor level meter lamp indicator" is in sale since Friday, November 26, 2010. This item is in the category "Vehicle Parts & Accessories\Motorcycle Parts\Electrical & Ignition Parts\Batteries".
The seller is "gammatronixlimited" and is located in kettering, Northamptonshire. This item can be shipped worldwide.