PLEASE READ THIS CAREFULLY AND TAKE NOTICE OF THE HEADSTOCK AND REAR WHEEL OPENING SIZES.... Shown in the FIRST FIVE'photos are a custom frame to suit Suzuki GSXR/F600,750,1100, GS750,1000, Bandit 600 and 1200, Kawasaki Z650,750 ENGINES but is NOT suitable for the water cooled models, the second picture is of the shorter version. The frame has engine mounts welded in place and the bolted brackets are supplied.The "jap" frames are available with a slightly shorter back end (picture #2 , about 90mm) which may be better suited to the bobber style. The standard Bandit (headstock is 200mm long and use the Bandit bearings - not supplied and NOT suitable for USD forks - read the blue bit close to the bottom) front end and rear wheel (opening is 254mm as the 1200 Bandit) will slip straight into the frame giving approximately 5 ground clearance (frame to ground). These frames are available for the Yamaha FJ1100/1200 models and look the same as the photos and are now supplied with all the engine mounts , also the headstock is set at 180mm and machined for FJ bearings (not supplied). The LAST FOUR'photos are a custom frame for Harley Davidson Sportster models (pre rubber mount engines only), the headstock is the standard 180mm length and machined for sportster bearings that aren't supplied. These frames come with welded mounts to accept your standard engine plates.
The model shown is for a belt or chain drive and the rear wheel opening is set at the standard sportster size but , on request, can be set to individual requirements. Again these frames, using standard running gear, give approximately 5 ground clearance. The materials used are 3.2mm wall thickness and 33mm diameter with 42mm diameter top tube and seat brace, the axle plates are 15mm thick with 20mm slots for the Suzuki and Yamaha frames and the Harley axle plates are also 15mm thick but have 19mm (3/4) slots. Although the frames feature a goose neck they can be supplied with straight down front rails (at the same price). PLEASE BE AWARE, THE ENGINE PICTURED IS FOR DISPLAY ONLY AND NOT INCLUDED IN THE SALE.Any questions please ask and thank you for looking. As I have and always will admit, my communication skills are ermm poor, when you order a frame it may be a while before you hear from me DON'T PANIC it'll be fine! Thank you for your patience!
The item "Chopper/lowrider/bobber/rigid frame" is in sale since Wednesday, July 3, 2019. This item is in the category "Vehicle Parts & Accessories\Motorcycle Parts\Bodywork & Frame\Other Bodywork & Frame". The seller is "bluefrogfabrications" and is located in Hartlepool.This item can be shipped to all countries in Europe.